CarPro - Lift Snow Foam

CarPro Lift is a highly concentrated pre-wash foaming agent that uses 13pH alkyl cleaning ingredients to dissolve and lift dirt in a completely touch-less manner. Unlike superficial high foaming products, CarPro has designed Lift as a true active surface agent with maximum wetting properties that rinses easily. The foam's bubbles burst and move during the dwell period, encouraging the proprietary blend of surfactants to bind with road grime for effective cleaning.

Always use CarPro Lift on cool surfaces. Dilute the product in your snow foam lance with water at a typical 1:10 ratio - you can use leaner ratios for a more flowing mixture or richer for denser foam. Apply the foam and allow it to dwell on the surface for at least 5 minutes (the longer the better), but never let it dry. After dwelling, rinse thoroughly and follow with a proper car shampoo wash.

Snow Foam & Foam Lances are essential for the pre-wash stage of car cleaning. This touch-less cleaning method helps remove the majority of dirt and grime before you physically wash your car, reducing the risk of scratches and swirl marks. Snow foam is particularly effective for heavily soiled vehicles or as part of a regular maintenance wash routine.

You'll need a pressure washer and a compatible foam lance to use CarPro Lift properly. The MJJC Foam Cannon S V3.0 works excellently with this snow foam, providing consistent foam coverage and the right dilution ratios. Make sure your foam lance is compatible with your pressure washer's connection type for optimal performance.

Yes, CarPro Lift is formulated to be strong yet gentle, making it suitable for use on all vehicle surfaces including paintwork, glass, and trim. The 13pH alkyl cleaning ingredients are effective at removing dirt while being safe for your car's finish. However, always ensure you're working on cool surfaces and never allow the product to dry on the vehicle.

The foam consistency depends on your dilution ratio. If your foam is too thin and flowing, use a richer mixture by reducing the water ratio. If it's too thick and not covering well, use a leaner mixture with more water. Start with the recommended 1:10 ratio and adjust based on your pressure washer setup and desired foam density. Also check that your foam lance is functioning properly and not clogged.