Bilt Hamber Touch-Less 1 Litre Concentrate
Bilt Hamber Touch-Less is the NEW double-concentrate version of the all loved pre-clean snow foam, which can be applied via pressure washer or with a trigger spray. This eco-friendly, biodegradable sugar based product provides excellent cleaning power whilst being kind to the environment!
Now double concentrate, Touch-Less improves the performance and decreases its pH – more concentrate, less to use! Unlike other petrochemical-based cleaners, Touch-Less is "free-and-easy rinsing" which eases the effort of following bucket washes and helping finishing stage products to bond easier.
Bilt Hamber Touch-Less is designed to allow for superior and simple application of Bilt Hamber's paint protection product Touch-On.
Touch-Less also contains corrosion inhibitors, is pH ~10.5, contains no phosphates, solvents, NTA, or caustic soda.
1 litre bottle.
How to use Bilt Hamber Touch-Less
Bilt Hamber TOUCH-LESS may be applied with trigger spray, pump spray, pressure washer, or snow foam lance. The minimum recommended dilution rate should be 0.5% PIR (Panel Impact Ratio) and up to 2% for very dirty vehicles. Where application is through trigger spray or pump spray, the dilution calculation is easy to achieve, however, for application with pressure equipment it is essential to determine the amount of water being delivered to the equipment reservoir.
Step 1 - Fill the detergent bottle or reservoir (on machine or lance) up to capacity with plain water. Turn detergent feed to full. Take a large bucket or container and discharge the lance into this, watching the detergent bottle until empty. Once empty, stop.
Step 2 - The following calculations will achieve 2% dilution; Measure the total amount collected and multiply this number by 0.02 (Total can be measured in either volume with a measuring jug or by weight) this is the amount of Bilt Hamber TOUCH-LESS to use.
Step 3 - Add the calculated amount from Step 2 to the pressure-washer reservoir and top up to full with cold water and shake in for a few moments.
Step 4 - Apply Bilt Hamber Touch-Less to entire vehicle or panel by panel. Allow to soak for 1-5 minutes (but never allow to dry). Power-wash off.
It is not necessary to use all diluted Bilt Hamber Touch-less in one wash. One litre of diluted product should last 4-5 washes. Apply to cool panels in shaded conditions. Do not allow this product to dry in use. Keep the bottle neck and lid clean.
