Gtechniq - EXO v5 Ultra Durable Hydrophobic Coating

How to use Gtechnic EXO v5

• Gtechniq EXOv5 can be applied as a standalone coating or as a top layer for Gtechniq C1 Crystal Lacquer or Gtechniq Crystal Serum Light (CSL) – we recommend applying C1 or CSL as a base coat for easy-to-mark and dark paints
• If you are applying over C1, EXOv5 should be applied a minimum of 4 hours, but less than 12 hours, after you finish the C1 application
• If you are applying over CSL, EXOv5 should be applied at least 1 hour after application of the CSL.
• Ensure that your vehicle is out of direct sunlight but warmer than 5 degrees Celsius, is completely dry and will stay dry for at least 12 hours after application
• Wipe down all surfaces using Gtechniq Panel Wipe and a Gtechniq MF1 ZeroR Microfibre Buff Cloth (apply the Panel Wipe directly to the cloth and not directly to the panel) – if you are applying over newly applied C1 or CSL, this step is not required
• Shake the bottle well and wear gloves
• Prime the AP2 Ultra Soft Foam Filled Applicator evenly with a good amount of product so that the pad is saturated
• Apply with the applicator provided in overlapping strokes to an area roughly 2ft by 2ft (60cm x 60cm). Wait for 1 to 2 minutes after applying to a panel and buff with an MF1, followed by a second MF1 to remove any smearing, leaving the surface slick. Just a single layer of product is required.
• Allow the coating to cure for at least 12 hours before exposure to moisture
• After application, we recommend that you do not wash the car for at least 7 days
• Store in a cool, dry place