APPLICATION INSTRUCTIONS

1. Always clean the surface before applying.
   
   
2. Remove the white backing sheet, leaving the sticker attached to the clear transfer sheet.
   
   
3. Apply the transfer sheet. Make sure there are no wrinkles in the decal or the transfer sheet.
   
   
4. Starting at the middle of the decal and work your way out, use a squeegee or credit card to apply pressure with smooth, even strokes.
   
   
5. Wait a few minutes to allow the adhesive to dry.
   
   
6. Apply pressure with the squeegee or credit card again to ensure the entire decal is on.
   
   
7. Carefully and slowly peel the transfer sheet off the decal.
   
   
   

   Note: Small bubbles may remain. These bubbles will disappear within a few weeks as the vinyl breathes and the application fluid evaporates.

   Large bubbles can be eliminated by carefully applying heat to the area with a hair dryer, puncturing them with a needle, and then applying pressure with your thumb.